1989 s10 blazer weight. 1989 Chevrolet S 2019-02-04

1989 s10 blazer weight

Chevrolet / Chevy Curb Weight

1989 s10 blazer weight

I use coil springs as slinkys. I just put a powerglide in and not sure the weight difference. A weak fuel pump or clogged fuel filter would cause a backfire through the intake condition. Posts: 923 Joined: Sun Apr 19, 2009 4:36 pm My cosin buddy's truck with 406 stroked to 421 tubbed,dana 60,powerglde with transbrake,14. The automatic transmission two-wheel drive models get 21 mpg in the city and 28 mpg on the highway. This is a little black box if you will that sits under the distributor cap.

Next

1989 Chevy S10 Specs

1989 s10 blazer weight

Answer i have the same question. It will be loud but you'll be able to see if that cures the problem. All S10 models are 64. Wondering what my 1984 2 door s10 blazer might weigh. You may need to use carburetor cleaner to assist it the removal since many of them may be slightly stuck.

Next

Chevrolet / Chevy Curb Weight

1989 s10 blazer weight

The four-wheel drive models feature a 2. I was the hippy in the shop swapping motors with buddy. The bore and stroke measure 4. This unit also contains the fuel pressure control valve. The compression ratio is 8.

Next

1989 Chevrolet S

1989 s10 blazer weight

All S10 models are 64. The four-wheel drive models feature a 2. I make engine noises when I post. If it has dual catalytics follow the drivers side exhaust pipe and it will be the one after the catalytic. I don't need luck, I have old age and treachery Posts: 2310 Joined: Tue May 15, 2007 8:37 pm Location: Holland, Mi.

Next

Chevrolet / Chevy Curb Weight

1989 s10 blazer weight

Exact location is governed, by installed options, such as Radio, Air conditioner. If it does, ream out the cat or replace it. If yours do not break, remove each of the lines noting the small o-ring and spray carburetor cleaner into each separate line to clean it out. A plugged Catalytic Converter would … most likely cause engine to bog and run very poorly maybe even stall or struggle to run, no power. Clogged air filter would cause poor engine operation and a possible rich fuel mixture. The wire that you're looking for can be found by pulling back the top of the passengers carpet. I make engine noises when I post.

Next

gyrohuman.com • View topic

1989 s10 blazer weight

Their manual transmission counterparts get 23 mpg in the city and 27 mpg on the highway. So there is no telling where is it now. The compression ratio is 8. The Regular Cab Short Bed models are 178. You'll probably hear an air sound out your exhaust system. The 1989 Chevrolet S10 is a pickup truck available in eight different trim levels. It's only held in place by two small bolts.

Next

1989 Chevrolet S

1989 s10 blazer weight

The Primary Filter, is located, inside the Frame Rail, about 12 Inches in Front of the Left Rear Tire. They're also fairly inexpensive to replace. Then there are the Two Screens, on the Fuel Injectors, but again, I have never had a problem wit … h them. It can be tested at most any auto parts store. All two-wheel drive models have a 2. Their manual transmission counterparts get 23 mpg in the city and 27 mpg on the highway.

Next

What is the weight of a 1989 S10 Blazer with a 4.3 liter V6

1989 s10 blazer weight

If you break a tab on removal or replacement, you must then replace the line. You must separately squeeze the t … wo tabs of each poppet line to remove it from its singular port placement. It's really easy to replace. The four-wheel drive models get 17 miles per gallon in the city and 22 mpg on the highway. Shoot, we even have windshield wipers.

Next

Chevrolet / Chevy Curb Weight

1989 s10 blazer weight

All two-wheel drive models have a 2. I am thinking the 2 door s10 blazer must be pretty light because I really don't think that my worn out ticking and tacking 350 produces more that 200-220 hp. Located under the Dash-board, inside the Passenger Compartment. Not recommended for the solo mechanic. .

Next