Allow the safety belt to retract to remove any slack in the belt. When in this position rotate the control upward for fast intervals and downward for slow intervals. Since this information is subject to. Service refill capacity is determined by filling the axle to the bottom of the filler hole with the vehicle on a level surface. Use of synthetic or synthetic blend motor oil is not mandatory. However, for severe usage or in high temperature climates, check the battery electrolyte level.
See Front passenger sensing system in the airbags section of this chapter. For additional information, refer to the Driving with a 4—speed automatic transmission section in this chapter. Ensure that the seat is relatched into place. Refer to Electric automatic temperature control in the Climate controls chapter. Pull the wiper arm away from the windshield and lock into the service position.
Lift the hood until the lift cylinders hold it open. The door s will lock again, the horn will chirp once and the lamps will flash. The following procedure applies to vehicles equipped with single rear wheels, if your vehicle is equipped with dual rear wheels it is recommended that only the front wheels be rotated side to side. Pull out the old bulb from the socket and push in the new bulb. Install the new bulb in reverse order. Press the control again to return to the playing media. Press again to return to the playing media.
Do not remove these components from your vehicle when using snow tires and chains. App Store is a service mark of Apple Inc. Transmission fluid requirements are indicated on the dipstick or on the dipstick handle. App Store is a service mark of Apple Inc. These messages indicate improper operation of the vehicle network communication between electronic modules.
Under-inflation or over-inflation may cause uneven treadwear patterns. Set the parking brake and shift to P Park. Follow the same steps to replace either bulb: 1. All fees and programming subject to change. Block the wheels to prevent the vehicle from moving unexpectedly. Ford recommends the use of a child safety seat having a top tether strap.
Move the control in the direction you wish to tilt the mirror. Adjust spotter mirrors if equipped manually. For added customer comfort, the air distributed through the floor ducts will be slightly warmer than the air sent to the windshield defroster ducts. High beams: Illuminates when the high beam headlamps are turned on. For more information on top tether straps, refer to Attaching safety seats with tether straps. These will not work until the vehicle is disarmed.
Our headlight had four bolts holding it in and 2 electrical plugs. Under no circumstance should these limitations be exceeded. Have your tow truck operator refer to this manual for proper hook-up and towing procedures for your vehicle. The head restraints can be moved up and down. The tone may also be heard if items in the truck bed protrude rearward outside the bed. Dry the area with a soft cloth. .
Not all vehicles qualify for A, Z or X Plan. If you need to use chains, it is recommended that steel wheels of the same size and specifications be used, as chains may chip aluminum wheels. Pull headlamp control towards you to turn foglamps on. Routine maintenance of the air bag is not required. Remove bulb socket from the parking lamp assembly by turning it counterclockwise.
Remove the bulb socket from the foglamp by turning counterclockwise. If a light fails to illuminate, have the vehicle serviced. If the safety seat is not anchored properly, the risk of a child being injured in a crash greatly increases. Secure the cover behind the cab with two straps. A correct zone setting will eliminate this error. Apple CarPlay is a trademark of Apple Inc. Service refill capacity is determined by filling the axle to the bottom of the filler hole with the vehicle on a level surface.
Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. Then, start the engine and complete the above driving cycle. Start the engine of the booster vehicle and run the engine at moderately increased speed. Place the transmitter into storage compartment, control down. Any time that the media is changed, new radio station, etc.