The auto door unlock operation will If this item is checked, the headlamp be canceled. Tire ply composition and mate- 6. Play Time Displays the current play time. Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line. Slide the the studs, put the wheel nuts on wheel off the studs and lay it flat so the studs and tighten them finger Wheels may have sharp edges. The audio system mecha- nism may be damaged if you spill them. Remove the cover with a phillips screw- driver.
At Palmer's Airport Hyundai, our expert staff will walk you through all the features of this vehicle. The driver's door will unlock. Remove the headlamp bulb cover dling it. To aim the low beam left or right, turn the driver 1 clockwise or counterclockwise. Keep receipts for all vehicle emission services to protect your warranty. The cut-off line should be projected in the allowable range shaded region.
Play Plays the currently paused song. When the which prevents shifting the transaxle pedal before and while shifting vehicle stops, 1st gear is automati- from P Park or N Neutral into R. Info Displays currently operating mode Displays detailed information for the current file Basic Mode Screen 2. Rear Cross-traffic Alert is active when the vehicle is in Reverse and backing at a speed less than 6 mph. Place the transaxle shift lever in N Neutral.
The auto door unlock operation will If this item is checked, the headlamp be canceled. This can increase fuel con- tion. Press the button of the outside Using the button on the smart key door handle. Loosen the retaining nuts and 5. To lower it, push it down 3 while Front seat pressing the height adjuster button 2. Crossrails and fixing components to adapt the roof rack on your vehicle may be obtained from an authorized Hyundai dealer. Input the coordinates of latitude by 6.
Dirty or improperly aimed headlights will make it much more difficult to see at night. Do not rely on your road. Placing items under fying your air bag-equipped if equipped the front seats could interfere with vehicle the operation of the supplemental If you modify your vehicle by chang- restraint system sensing compo- ing your vehicle's frame, bumper sys-. After complete inflation, the airbag immediately starts deflating, enabling the driver to maintain forward visibility. Always remove the ignition key for their safety. If the disc is not removed, after 25 seconds, the disc will be automatically pulled back into the re-.
We recommend that the system be inspected. You can now remove the disc. Store them in their original cases or other protective cases away from direct sunlight and dust. On a sion, an unbelted occupant is steer sharply. Blind Spot Detection is only meant to assist the driver in these responsibilities. The front should be loaded with approximately 60% of the total trailer load; the rear should be loaded with approximately 40% of the total trailer load.
Please see owners' manual for additional information. This available system controls engine power, torque and braking between the front and rear wheels to create exceptional road-holding capability. This should be done even if no damage is visible. Remove the bulb by pulling it straight out. Press on the control panel. To aim the high beam up or down, turn the driver 3 clockwise or counterclockwise. Turn the low beam on with the driver 75 kg aboard.
Slowly allow the shoulder portion 5. However, some commands may not be supported in special circumstances. They are: o Be careful not to spill battery electrolyte or hydraulic brake fluid on the bumpers. After you've loaded your trailer, weigh the trailer and then the tongue, separately, to see if the weights are proper. Reassemble in the reverse order of disassembly. If the driver watches battery. Turn on the interior light.