Fuel Gauge This indicator will illuminate when the front fog lights are on. Mount the road tire on the axle. These are not a reason to replace belt. Pull down on the rear 5. If you are While driving off-road, you will encounter many types of going to be driving on large soft sandy areas or dunes, terrain.
Continued sures before trailer usage. Stow the windows carefully to avoid scratching. Unplug the wiring harness connector. These non-adjustable outlets direct entering the cabin. Unhook the door strap from the body hook. Raise the vehicle only enough to remove the tire.
Pull on the strap to tighten the Freedom bag securely against the rear seat. Make sure the plastic sleeves are slid rearward over 16. Locate the straps to secure the side bows. Install the rear door frame first. The power inverter switch is located on the instrument panel below the climate controls. If a bulb needs to be replaced, visit your authorized dealer or refer to the applicable Service Manual. Grasp the folded side bows and lift to the top of the 5.
Zipper pulls will stay on the rear window. It is located on the lower left part of the cluster below the speedometer. If you depart from the original route, your route is recalculated. If your shift is needed either up or down. Disconnect the opposite end of the negative - jumper cable from the negative - post of the booster battery. Driving in the 4H and 4L positions on hard-surfaced roads will cause increased tire wear and damage to the driveline compo- nents. If one wheel The Anti-Lock Brake System is subject to possible on a driven axle is spinning faster than the other, the detrimental effects of electronic interference caused system will apply the brake of the spinning wheel.
Visa, Mas- charts and detailed illustrations. Therefore, do not add any fluid addi- tives to the transmission. Ensure that the straps are positioned correctly before Partially install the sail panel retainers into the body side pulling the sail panels over the rear roof bow 4— channel, leaving the last 3 in 7. The seat belt still must be We recommend that pregnant women use the seat belts worn snugly and positioned properly. Seat Belts Defroster Inspect the seat belt system periodically, checking for.
Operate the jack from the front or the rear of the vehicle. The lockable glove compartment is located on the pas- senger side of the lower instrument panel. If you have two valid Sentry Keys®, you can program Always remove the Sentry Keys® from the vehicle new Sentry Keys® to the system by performing the and lock all doors when leaving the vehicle unat- following procedure: tended. Push the top prevent possible damage to the rear center high- rearward to disengage. Your at- Uconnect® features Bluetooth® technology - the global tention should be focused on safely operating the standard that enables different electronic devices to con- vehicle.
Remove the two inboard screws attaching the tail light fog lamp. Lower the vehicle by turning the jack screw to the left, Road Tire Installation and remove the jack. Install the soft top with the pivot brackets above the sport bar brackets, lower the soft top into the sport bar bracket slots in a downward motion to lock tab on soft top. To remove the wiring harness press the tab and pull right. To avoid this, do not apply There may be situations on minor hills with a loaded throttle while pressing the clutch pedal until you are vehicle, or while pulling a trailer where the system ready to release the clutch. Engine Temperature Gauge See page 117 for Instrument Cluster Indicator Lights. Return to heating, take the following actions: a higher gear or vehicle speed when grade and road City Driving.
Amber indicator lights in each switch indicate the level of heat in use. Operation is subject to the following conditions: The Uconnect®. Adjusting the steering column while driving or driv- ing with the steering column unlocked, could cause the driver to lose control of the vehicle. Zipper pulls will stay on the rear window. After the door frame pin has been set into the body Door Frame Installation — Two-Door Models — If side hole, carefully set the front of the door frame into Equipped the rubber seal at the top of the windshield.