It is recommended that the original clutch tube with quick connect be replaced when servicing the hydraulic system because air can be trapped in the quick connect and prevent complete bleeding of the system. Slide the white plastic sleeve toward the slave cylinder while applying a slight tug on the tube. Remove the nut, washer and insulator from the upper shock absorber mount at the frame bracket and remove the shock absorber. Remove the retainers and the stabilizer bar and bushings from the vehicle. Coat the new bearings with clean 50W engine oil and install them with the tool. Before removing the drive shaft, matchmark the driveshaft in relationship to the flange on the transfer case and the flange on the rear axle so that it may be installed in its original position.
Upper intake manifold bolt tightening sequence Click to enlarge Install the upper intake manifold using a new gasket. Never pull on the wire Using compressed air, blow any water or debris from the spark plug well to assure that no harmful contaminants are allowed to enter the combustion chamber when the spark plug is removed. A well charged battery should register over 12 volts. Tighten the mounting bolts until snug. Press in 1 inch 25. Drain the rear axle lubricant. If applicable, insure to distinguish between intake and exhaust springs.
If the endplate is not within specifications, the wheel bearings must be replaced. If removed, install the fuel tank skid plate. Disconnect the driveshaft from the front axle yoke. Refer to the necessary service procedures in this section. While it should not be necessary, have the wheel alignment checked by a professional shop.
Remove the disc brake calipers and support the caliper on the vehicle's frame rail. The use of premium grades may actually cause driveability problems. Rotate the crankshaft one revolution. Remove all traces of gasket material. Remove the lower manifold and its gasket from the engine.
Fuel pressure regulator on the 2. Using a sharp punch and hammer, drive a hole in the rear bearing bore plug and pry it out. Choose an aluminum compatible, good quality antifreeze with water pump lubricants, rust inhibitors and other corrosion inhibitors along with acid neutralizers. In 2008 alone, Ford produced more than 5. Raise and support the vehicle safely.
To install: Ensure that the wiper motor pivot shaft is in the park position. Remember that some longer exhaust pipes may be difficult to wrestle out from under the vehicle if it is not supported high enough. Install the air conditioning compressor. Carefully pry the wiper arm from the shaft. Install the wheel and tire assembly. No maintenance or service should be required, except in the case of damage or malfunction. Reconnect the negative battery cable.
When using silicone rubber sealer, assembly must occur within 15 minutes after sealer application. Unplug the vehicle wire harness connector from the shock absorber pig tail plug. Make sure that the sealing ring is properly installed on the thermostat rim. Remove the auxiliary shaft sprocket. If scraping is necessary, be careful not to damage the fuel pressure regulator or supply line gasket mating surfaces.
Disconnect the hydraulic coupling at the transmission. Remove the housing and thermostat as an assembly. © 2004 Thomson Delmar Learning. Remove the thermostat housing bolts. Place a drain pan under the transfer case, remove the drain plug and drain the fluid.
Ensure that the flywheel is removed. Ford is one of the most popular auto makers in the world. Be sure the terminal connector inside the insulator is fully seated. Select your Ford model below:. Remove the valve spring and retainer from the cylinder head If equipped, remove the valve seal. Pull the gauge from the cluster.
Cut off the old gasket around the cylinder cover and use half of the new gasket on the auxiliary shaft cover. Ensure that the lower shock attaching nuts do not become obstructed by the jackstands. On 1992 and later vehicles, there are two styles of thumb wheel adjusters. No drag must be present on the axle. I hope you enjoy visiting our site today, and that you find this information useful. Have the alignment checked by a professional repair shop. Invert it and fully compress and extend it at least 3 times.